Model CXXXX- Custom Kit - Up to 100 Tons

 

 Model CXXXX Diminisons Drawing - Figure 1

The Model CXXXX Custom Kit CostGard™ Condensate Drain Seal is applicable to draw-through systems with requirements beyond the capability of the Model 1525 Basic Kit, defined as follows:

  • Cooling capacities up to 100+ tons
  • Drain diameters of 1.0 inch to 2.0 inches
  • Drain pan negative pressure: 0 to -5.0 inches of water

A photograph of this model along with a sketch showing basic dimensions are shown in Figure 1. Table 1 defines the dimensions for selected CXXXX Models and the capabilities of each. Like Model 1525, the Model CXXXX consists of 3 parts, identified in Figure 1 as A, B and C. These parts provide versatility in installation. For example, by rotating Part C in Part A, the discharge Part B can be pointed in various directions. Part B can be rotated up to 60 degrees to allow pipe alignment.

Typical Custom Kit Installation Drawings:

Detail installation drawings and instructions are provided with each Custom Kit.

Model CXXXX Diminisions - Table 1

Custom Kit Photo