Back

 

PHOTOGRAPH AND SCHEMATIC DRAWING

CostGardTM Condensate Drain Seal   MODEL CXXXX

 

 

 

Like Model 1525, the device consists of three parts, identified in Figure 2 as Parts A, B, and C. These parts provide versatility in installation. For example, by rotating Part C in Part A, the discharge port Part B can be pointed in the desired direction. Part B can be rotated up to 60 degrees to allow piping alignment.

 

The dimensions and characteristics of some custom-built models are listed in the Table below. Each model, applicable to any size draw-through HVAC system up to 100 tons cooling capacity, is constructed to meet the operating pressures required by the customer. The CostGard™ Condensate Drain Seal shown in the SCHEMATIC DRAWING above has a 1-1/2” drain however; the custom built device can be made to accommodate condensate drain pan connections from 1 to 2 inches in diameter. General installation instructions and special considerations applicable to custom-built models are provided with each model shipped.  Installation Instructions

CUSTOM-BUILT CostGardTM CONDENSATE DRAIN SEAL

CXXXX MODELS

FOR UNITS WITH COOLING CAPACITIES UP TO 100 TONS

 

Maximum

Negative DRAIN

Pan pressure

 

model

Number

 

Depth

of

Drain

Seal

 

Length

 

DRAIN DIAMETERS AVAILABLE

A

B

C

D

1.5 in. wc

C1500

6.0 in.

9.0 in.

1.0 in.

1.25 in.

1.5 in

2.0 in

2.0 in. wc

C2000

6.0 in.

9.0 in.

1.0 in.

1.25 in

1.5 in

2.0 in

2.5 in. wc

C2500

6.0 in.

9.0 in.

1.0 in.

1.25 in

1.5 in

2.0 in

3.0 in. wc

C3000

6.0 in.

9.0 in.

1.0 in.

1.25 in

1.5 in

2.0 in

3.5 in. wc

C3500

7.0 in.

9.0 in.

1.0 in.

1.25 in

1.5 in

2.0 in

4.0 in. wc

C4000

8.0 in.

9.0 in.

1.0 in.

1.25 in

1.5 in

2.0 in

4.5 in. wc

C4500

9.0 in.

9.0 in.

1.0 in.

1.25 in

1.5 in

2.0 in

5.0 in. wc

C5000

10.0 in.

9.0 in.

1.0 in.

1.25 in

1.5 in

2.0 in

Back